Retrotec Triple Fan Blower Door System Setup with DM-2 User Manual download pdf

Page 1 of 6

QG320 rev-2011-10-10

QuickGuide-Blower Door-QMG 3 Gauge

 Read and experiment with each step

 To perform automatic or multi-point tests*, refer to the FanTestic Software Manual and the DM-2 Operator’s Manual

*Tests for CGSB 149, LEED, ASTM E778, ASTM 1827, EN13829, and ATTMA TS-1 may require more elaborate steps and training. This guide is

intended only for familiarization with the controls.

For the latest Retrotec documentation, visit us at: http://www.retrotec.com/

1 Setup the DM-2s

1.1 Setup the DM-2s as needed for the required

testing standards

See: QuickGuide-DM2MkII

1.2 Ensure that rechargeable

batteries are fully charged

(may take eight hours or

more), or that spare

batteries are available for

each gauge.

2 Set up the building

2.1 Close the outside doors and windows.

2.2 Open all interior doors leading to conditioned

spaces.

2.3 Shut off HVAC (exhaust fans, dryers, A/C,

furnaces).

2.4 Turn gas hot water to pilot.

2.5 Place paper over any open ashes.

Close all windows

Gas valve to Pilot

Cover ashes with paper

Fans must be plugged into three

separate circuits!

1 2 3 4 5 6

Summary of Contents

Page 1 - 2 Set up the building

Page 1 of 6 QG320 rev-2011-10-10 QuickGuide-Blower Door-QMG 3 Gauge  Read and experiment with each step  To pe

Page 2 - Page 2 of 6

Page 2 of 6 3 Unpack the fan panels 3.1 Remove the 3-Fan panel from the case. 3.2 Stand the panel on its side, and unfold the sections. 3.3 Lock b

Page 3 - 12 Connect DM-2 #1 to Drive

Page 3 of 6 9 Seal any remaining gaps 9.1 Depending on the height of the doorway, a gap may be left open between the top of the panel and the door f

Page 4

Page 4 of 6 13 Connect the variable speed drives 13.1 Plug each drive into a 20 amp outlet (not GFCI), on an independent circuit, to avoid tripping t

Page 5

Page 5 of 6 20 Remove fan cover and set range 20.1 Remove the fan covers from all three fans. 20.2 All three fans should be open, with all range pla

Page 6 - 26 Securing the 6-Fan system

Page 6 of 6 25 Setting up a 6-Fan system 25.1 If additional airflow is required, six fans can be connected and controlled together. 25.2 Connect two

Comments to this Manuals

No comments

Retrotec Triple Fan Blower Door System Setup with DM-2 User Manual

Browse online or download User Manual for Safety Retrotec Triple Fan Blower Door System Setup with DM-2. Retrotec Triple Fan Blower Door System Setup with DM-2 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Safety Retrotec Triple Fan Blower Door System Setup with DM-2