Retrotec DM32 User Manual download pdf (Page 52)

Page 52 of 94

©Retrotec Inc. 2014

the gauge via USB with the DM32 Configurator software on the computer. For instructions on setting

network password into the DM32, see section 5.5.1.

The Static IP parameters for use with a wireless network are set up in the same manner as for a wired

network (described in section 5.2).

Once the secure wireless network credentials have been set into the gauge using DM32 Configurator

software, the user should verify these credentials on the DM32 itself, as described in section 5.5.2.

5.5.1. Set secure wireless credentials using DM32 Configurator software

Figure 61: Use Gauge Configurator software to change wireless networking parameters

1. Install the USB Device Driver, if not already installed

2. Connect the DM32 to a Windows-based computer via USB cable

3. Start DM32 Configurator software

4. The DM32 gauge serial number should show up on list automatically and you should highlight the

gauge(s) you want to configure

5. Click the “Network” button (one of the buttons along the bottom)

6. Choose “WiFi” as the Network Status

7. Enter your WiFi router's Network Name (SSID) in the “WiFi Settings” section.

8. If secure, click on “Secure Network” and enter your WiFi router's “Password”.

9. If necessary, click “Advanced” and select your WiFi router's security type from the drop down

choices (default is fine in almost every case).

10. Click “Save to Gauge”. If you want the same parameters entered into all gauges currently

connected to the Configurator, click “Copy to All Gauges”.

11. It is now safe to disconnect the DM32 gauge(s) from the PC, and verify the connection

5.5.2. On DM32, verify wireless credentials after updating

If using [DHCP] addressing, verify the gauge has obtained a network address by checking the white text on

the [IP address] key for an IP address that is valid on your network.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 93 94

No comments

Retrotec DM32 User Manual Page 52